100m American Walnut Timber Veneer Edging

1. Substrate Surface – Remove laminate or paint using coarse sandpaper and/or paint stripper. Clean-up substrate surface using stiff-bristled brush.
2. Iron-on Timber Veneer Edging – Measure and cut edging allowing 10mm overlap on each end.
3. Domestic Iron – Turn off steam function. Set iron to high heat (cotton setting).

1. Position Edging – Lay edging over substrate allowing equal overlap ona ll sides for trimming.
2. Cover Edging (not vital) – Cover edging strip with brown or grease proof paper to protect surface of edging from excessive direct heat from iron. (see illustration A)
3. Iron-on – Use on hand to guide and keep edging in position. Starting at one end, iron back and forth. Slowly continue forwards. (see illustration A)
4. Follow-up Pressure – Rub wooden block or push roller back and forth immediately after ironing (whilst edging and adhesive still warm) to keep edging in contact with substrate surface as adhesive cools. (see illustration B)
   • Note - If result is not acceptable, re-work by repeating steps 3 and 4.
5. Trimming – Ideally use a router. Alternatively: With fine file - Move file at close angle (15 º) to surface of board. With chisel or utility knife - Work along surface of substrate. Trim carefully to avoid damaging surface of substrate. In all cases, work away from edging towards surface of substrate to stop edging pulling away.
6. Finishing – If required, fine sandpaper trimmed edges to smooth finish. If desired, Iron-on Timber Veneer Edging can be stained. Apply any standard timber finish.

Options

• 290368P/G
• 290372
• 290371
• 290368
• 207-571
• 290283