Megapoxy PF Rapid Set Epoxy Paste Adhesive

Features & Benefits

• Fast cure: Sets in 3–5 minutes.
• Ideal for on-the-spot critical repairs and fixings.
• Non-sag for vertical, inclined or overhead work.
• Smooth, workable, easy 1:1 mix ratio.
• High-strength bonds and chemical resistance.
• Two-part solution

Ideal Uses

• Concrete Repair
• Fibre Cement Sheet
• Bonding Steel to Concrete
• Bonding Natural Stone

Colours

Grey, White

How to Use

Megapoxy PF is a two-part, rapid set epoxy paste adhesive for many types of bonding and filling applications.

It is available in conveniently pre-packaged 1 litre, 4 litre and 20 litre kits with a simple 1:1 mix ratio.

It has a 3 minute work time and a 1 hour cure time at 25ºC.

Surface Preparation

Before beginning to mix, ensure that all contact surfaces like metal, concrete and stone are clean and free of oil, dust and any other surface contaminants.

Concrete and stone surfaces should be prepared by grinding the surface and removing all the dust and debris.
This helps ensure effective bonding contact.

Compressed air can be used to remove dust from cracks and holes.

Clean metal surfaces with acetone to remove any oils or contaminants.

Safety and PPE

Megapoxy PF is VOC-free. As with all epoxy resins, please wear appropriate PPE, including eyewear gloves and clothing.

Mixing

IMPORTANT. Only make a suitable quantity that can be used within the 3-minute work time!

Megapoxy PF should be mixed on a non-porous, flat surface.

Using individual spatulas for Part A and Part B, measure out equal amounts from their containers. Place them next to each other on the mixing surface. Ensure you have the same height and roundness for both parts BEFORE combining.

To combine, start by using the spatulas to fold part A over part B and then work them together in a zigzag motion.

Make sure to scrape underneath the combined product and onto the flat mixing surface. This will help to collect and combine any unmixed part A or B.

While mixing the epoxy, make sure to clean the spatulas by scraping off any un-combined Part A or part B and then mix thoroughly.

When the epoxy appears completely streak-free and uniform in colour, it’s ready for use.

Application

Megapoxy PF is recommended for bonding pre-cast concrete; natural stone; bricks; ceramics; and metals.

It is ideal for filling and repair of concrete pipes and tanks; fibreglass; patching concrete floors; stairs; concrete columns; and in situ formed concrete.

Because it’s rapid setting, Megapoxy PF can be used in combination with Megapoxy PM to secure vertical articles while it cures.

Applying Megapoxy PF to cracks and holes is easy and fast, and because it’s low-sag and rapid-setting, Megapoxy PF is ideal for overhead or vertical surfaces.

Clean-up

Uncured Megapoxy PF can be cleaned with Megapoxy Thinners. Please Dispose of contents and container in accordance with local, regional, national and international regulations.

Finishing

It will cure stronger than concrete with good chemical resistance.

Once cured, Megapoxy PF can be machined, sanded and polished to a fine finish.

For further technical information, refer to TDS.